Handpoint

SmartPOS Payments

Pax A920

...

Before starting your Handpoint SmartPOS solution with the Pax A920, the card reader should ideally be fully charged.
But beforehand, you need to:

1. Push the battery cover slide latch (at the back of the card reader) to the right to open

2. Remove the battery case (lift from the bottom)

3. Lift out the battery (lift from the bottom)

4. Remove the battery protective strip from the battery connectors (this is important)

5. Re-insert the battery and casing, pushing back the cover slide latch to the left

To charge the card reader, plug the micro USB connector to the micro USB port on the left side of the terminal.

...



For Wi-Fi Connectivity:

1. Turn on the card reader by pressing and holding the power button on the right side for 2-4 seconds

2. Use the touch screen to bring the settings bar down from the top of the screen. You must pull it all the way down until the settings appear in full with icon names

3. Select the Wi-Fi name (below the Wi-Fi icon)

4. Select the toggle switch to enable Wi-Fi

5. Once the list of available Wi-Fi networks appear, select your desired network

6. When your card reader has successfully connected to the network, it will confirm this action by displaying “connected” below the network name

For Cellular Connectivity:

You will be provided with a mini-SIM that is exclusively configured for you and likely to be already installed in your card reader.
To check your SIM is already installed, please follow the following steps:


1. Make sure your card reader is turned off using the power button

2. Push the battery cover slide latch (at the back of the card reader) to the right to open, remove the battery case (lifting from the bottom) and take out the battery (also lifting from the bottom)

3. Once removed, you should see your SIM card in the SIM1 card slot (on the left-hand side) otherwise insert it here (see the below image)

4. Re-insert the battery and casing, after which you need to push the cover slide latch back to the left

...

To activate your cellular connectivity, you will need to follow the following instructionsHandpoint provided SIM card, all you need to do is:

1. Turn on the card reader by pressing and holding the power button on the right side for 2-4 seconds

...

Select the Settings application and the following steps:

...

1. Connect the terminal to the WiFi 

2. Open the Handpoint app and go to the app settings (cogwheel)

3. Click the "activate sim card" button (might require to scroll down a bit)

At this time the device should be able to be used only with the SIM card.

Printing

The Pax A920 includes an in-built printer for printing receipts with a thermal paper roll. 
Here are the steps for changing the printer paper roll:

1. On the back of the card reader, pull down the paper lid release leaver and take the whole lid casing away

2. Remove the paper roll by simply pulling it out of the slot

3. Insert the new thermal paper roll in the same slot with the glossy side of the paper sheet facing out the top

4. Pull out around 2 inches of the paper sheet and close the close over it, until the lid snaps into place

5. Tear off any excess paper

Now your card reader is ready to produce receipts after a transaction.

Taking payments

Now you are ready to take payments with your Handpoint card reader, please have a look at our user guide for the Handpoint Payments app (smartPOS app): Getting started with the Payments app